磁力反應釜

磁力反應釜使用須知：
1、在磁力反應釜操作前，應仔細檢查有無異狀，在反應釜正常運行中，不得打開上蓋和觸及板上之接線端子，以免觸電。
2、應定期對磁力反應釜測量?jī)x表進行校準，以保證準確可靠地工作。
3、磁力反應釜升溫速度不宜太快，加壓亦應緩慢進行，尤其是反應釜攪拌速度，只允許緩慢升速。如遇停電，應即將調速旋鈕調回零位。
4、磁力反應釜不得速冷，以防過大的溫差壓力造成損壞。
5、磁力反應釜運轉時，聯軸器與釜蓋間的水夾套必須通冷卻水，以控制反應釜磁鋼的工作溫度，避免退磁。
6、磁力反應釜嚴禁在高壓下敲打擰動螺栓和螺母接頭。
7、磁力反應釜爆破膜在使用一段時間后，會老化疲勞，降低爆破壓力，也可能會有介質附著，影響反應釜靈敏度，應定期更換，一般一所更換一次，以防失效。
8、磁力反應釜嚴禁帶壓拆卸。

Magnetic reactor use instructions:
1. Before the operation of the magnetic reactor, carefully check whether there are any abnormalities. During the normal operation of the reactor, the upper cover and the terminals on the touch panel should not be opened to avoid electric shock.
2. The magnetic reactor measuring instrument should be calibrated regularly to ensure accurate and reliable operation.
3, the temperature of the magnetic reactor should not be too fast, the pressure should also be slow, especially the stirring speed of the reactor, only allow slow rise. In the event of a power outage, the speed control knob should be turned back to zero.
4. The magnetic reactor should not be cooled quickly to prevent damage caused by excessive temperature difference.
5. When the magnetic reactor is running, the water jacket between the coupling and the kettle lid must pass cooling water to control the working temperature of the reactor magnet and avoid demagnetization.
6. The magnetic reaction kettle is strictly prohibited to tap the bolt and nut joint under high pressure.
7. After the magnetic blasting blasting membrane is used for a period of time, it will age and fatigue, reduce the bursting pressure, and there may be medium adhesion, which affects the sensitivity of the reactor. It should be replaced regularly, and usually replaced once to prevent failure.
8. The magnetic reaction kettle is strictly prohibited to be removed by pressure.